Sheet selection option not working when over 9

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
DanFecteau
eCabinets Beta Tester
Posts: 278
Joined: Tue, May 10 2005, 12:00PM
Location: St-Odilon, Quebec, Canada
Contact:
Contact DanFecteau

Sheet selection option not working when over 9

Post by DanFecteau »

It seems this option is not working when I need to input a two digit number....I get something like \" unable to create label \" ????
Top
Nick M Singer
Guru Member
Posts: 828
Joined: Fri, Jun 17 2005, 12:23AM
Location: South Africa

Post by Nick M Singer »

Dan, say what????
Top
DanFecteau
eCabinets Beta Tester
Posts: 278
Joined: Tue, May 10 2005, 12:00PM
Location: St-Odilon, Quebec, Canada
Contact:
Contact DanFecteau

Post by DanFecteau »

I'm talking about the sheet selection option, as it's said in the \"subject\"
Top
David Hall
eCabinets Beta Tester
Posts: 593
Joined: Tue, May 17 2005, 12:41PM
Location: Stamford, CT USA
Contact:
Contact David Hall

Post by David Hall »

Dan,
I use it all the time, never had a problem jumping to any sheet number... including two digit numbers. Does the G-code for the sheet you want actually exist in the CNC file?


Regards,
Dave
David Hall
Hall's Edge Inc.
eCabinets Machining Services
http://www.HallsEdge.com
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”