countertop thickness

Jay Waters · Post by **Jay Waters** » Thu, Jul 05 2007, 11:04AM

Is there any way to change the thickness of the countertop while using the countertop editor, or does it use a pre-defined sheet thickness from our sheet stock? I need a countertop around 1 1/2\" thick. If it isn't possible with the editor I'll go ahead with a display cube. Thanks.

Jay Waters · Post by **Jay Waters** » Thu, Jul 05 2007, 12:35PM

DOH!! It's just one of them days. I found it under the Material Selection. I had already added some in some time ago. If you don't use it, you lose it!

Jean G Voyer · Post by **Jean G Voyer** » Thu, Jul 05 2007, 12:36PM

You do it in the 'Define stock editor'.

Michael Yeargain · Post by **Michael Yeargain** » Sat, Jul 07 2007, 5:30PM

OOps