The last job I ran I lost all my hinge plate holes and part editor cuts. All my drawer slide holes remained intact. Is this just a fluke or is there something I should look for. I made sure all the holes were there before creating the TWD file.
I am running Ecab version 5.2.
Zach
Losing Holes and PE cuts
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Zach Froble
- Senior Member
- Posts: 171
- Joined: Tue, Jun 21 2005, 3:23PM
- Location: Connellsville, PA
Losing Holes and PE cuts
Lyndan Designs
Machining and CAD Services
Machining and CAD Services
-
Todd Miller
Zach,
We are up to build 3 in Ecabs. Also what version of Control Nesting are you running? We are up to 5.31 in CN. Try updating both to the current versions then see if the problem still exists.
Note: We are aware of some graphical issues within control nesting. Sometimes the holes will not show up when nesting within control nesting. But when the parts cut the holes are there.
We are up to build 3 in Ecabs. Also what version of Control Nesting are you running? We are up to 5.31 in CN. Try updating both to the current versions then see if the problem still exists.
Note: We are aware of some graphical issues within control nesting. Sometimes the holes will not show up when nesting within control nesting. But when the parts cut the holes are there.