This won't load

Ray Jorgensen · Post by **Ray Jorgensen** » Fri, Jul 20 2007, 6:47AM

Here is a board that will be the front of a trash bin. I used a DXF file to get the letters and did the rest in the part editor. Every thing looks good but it won't pull up in control nesting. Any suggestions?

I've ziped and attached the .twd -.dxf and .esa files.

Justin Melhiser · Post by **Justin Melhiser** » Fri, Jul 20 2007, 8:10AM

Ray

If you change the part from a display board to a display panel then it will nest at the machine. If you have any more questions feel free to call me or send me an email. My number is 1-877-880-4638 and my email is cabinets@thermwood.com.

Thank You
Justin

Ray Jorgensen · Post by **Ray Jorgensen** » Fri, Jul 20 2007, 8:51AM

I'll do it!!! I thought only cubes didn't nest. Learn something every day.

Thanks

Thermwood / eCabinet Systems

This won't load

This won't load