importing DXF

jim graham · Post by **jim graham** » Tue, Jul 24 2007, 2:10PM

I am trying to import my Logo which i have saved as a dxf from turbo cad, but it wont load into the LDE. any ideas? i attached the file...

Justin Melhiser · Post by **Justin Melhiser** » Tue, Jul 24 2007, 2:49PM

Jim

There is no files attached to the post. Could you post it again.

Thank You
Justin

jim graham · Post by **jim graham** » Tue, Jul 24 2007, 3:23PM

Justin, i tried to send you an email reply but it wouldnt go thru. anyways, upon investigation, i found the forum doesnt allow dxf files, send me an email to jimswoodworks@frontiernet.net & i will send the file to you.

Thermwood / eCabinet Systems

importing DXF

importing DXF

Justin, your email address is invalid...