Can you design mdf doors that are routed out with a sticking patern?
The thermwood doors look like a traditional frame and panel style.
I want to create a flat panel look with a thumbnail bead sticking pattern.
Mdf Doors,Sticking patern
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Joe Murphy
- Junior Member
- Posts: 73
- Joined: Wed, Nov 30 2005, 9:26PM
Mdf Doors,Sticking patern
Joseph Murphy
President
Highland Woodworking
Nelsonville, NY
President
Highland Woodworking
Nelsonville, NY
-
Brian Shannon
- eCabinets Beta Tester
- Posts: 979
- Joined: Thu, May 19 2005, 10:50PM
- Location: Los Alamos, CA
Joe,
I think you could make a tool like the one I used on the outside. Just use it for the inside. You may still have to use a 1/4\" panel behind the beaded frame. I tried to create a tool for a flat shaker panel but there were errors.
I can post the .tol if you want.
Brian
I think you could make a tool like the one I used on the outside. Just use it for the inside. You may still have to use a 1/4\" panel behind the beaded frame. I tried to create a tool for a flat shaker panel but there were errors.
I can post the .tol if you want.
Brian
- Attachments
-
- beaded door.jpg (41.56 KiB) Viewed 3451 times
