Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Nick M Singer
- Guru Member
- Posts: 828
- Joined: Fri, Jun 17 2005, 12:23AM
- Location: South Africa
Post
by Nick M Singer »
Has this been posted before? I set up 2 drawer pulls per front at the same distance from the top and they come out as per pic.
-
Attachments
-
- DRAWERPULLS.jpg (65.28 KiB) Viewed 2956 times
-
DanEpps
- Wizard Member
- Posts: 5852
- Joined: Thu, Jul 28 2005, 10:18AM
- Company Name: Dan Epps
- Country: UNITED STATES
- Location: Rocky Face GA
Post
by DanEpps »
I tried and have no problem Nick. What happens if you use centered for the top/bottom location?
-
Nick M Singer
- Guru Member
- Posts: 828
- Joined: Fri, Jun 17 2005, 12:23AM
- Location: South Africa
Post
by Nick M Singer »
That works just fine Dan, its only if I specify a hight.
-
DanEpps
- Wizard Member
- Posts: 5852
- Joined: Thu, Jul 28 2005, 10:18AM
- Company Name: Dan Epps
- Country: UNITED STATES
- Location: Rocky Face GA
Post
by DanEpps »
I tried it both ways and the pulls locate properly. Have you deleted the pulls and put them back on?
