I am having problems when printing out nests, I have a list of 24 sheets but only want to print 1-8. The printer will print the 1st and 2nd. sheets with page numbers, than jump to sheets 11-18 with out page numbers. Also a box comes up on screen telling me that e-Cabs. needs to close.
I have tried using both of my printers, and the same thing happens.
I think I remember reading about this printing problem before, and I did a search but couldn't find it.
David Werkheiser
Printing nest
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
David Werkheiser
- Junior Member
- Posts: 27
- Joined: Tue, Aug 08 2006, 9:43AM
- Location: Lancaster, PA
-
Justin Melhiser
-
Justin Melhiser
David
You could also email me the files if you would like. My email is cabinets@thermwood.com
Thank You
Justin
You could also email me the files if you would like. My email is cabinets@thermwood.com
Thank You
Justin
-
David Werkheiser
- Junior Member
- Posts: 27
- Joined: Tue, Aug 08 2006, 9:43AM
- Location: Lancaster, PA
Justin, sent you the files,(I hope), I noticed that after I hit the \"Perform Nest\" button, a box pops up \"not found in Sheet Stock for the.\"
When I print out a whole job of 24 sheets it starts out:
1-2 jumps ahead to 11-18, back to 3, ahead to 19-24, back to 4 , ahead to 25-26 and back to 5-10. Not a problem when printing out whole job, just resort, but sometimes there are sheets I don't want printed.
Thank you, David Werkheiser
When I print out a whole job of 24 sheets it starts out:
1-2 jumps ahead to 11-18, back to 3, ahead to 19-24, back to 4 , ahead to 25-26 and back to 5-10. Not a problem when printing out whole job, just resort, but sometimes there are sheets I don't want printed.
Thank you, David Werkheiser
