nesting bottom half of sheets only

Michael Yeargain · Post by **Michael Yeargain** » Wed, Sep 19 2007, 8:14PM

I just installed the software on a HP media center, which is probably a mistake to begin with. The nest will ony use half the sheet, no mater how I arrange the nest. True shape or cut line.

Any thoughts.

DanEpps · Post by **DanEpps** » Thu, Sep 20 2007, 5:40AM

Media Center shouldn't cause a problem Mike as it is just another program that runs on top of XP.

Check your collar setting to see if it might be causing the parts to nest like that.

Michael Yeargain · Post by **Michael Yeargain** » Thu, Sep 20 2007, 5:41AM

Colar is 1/2\" just like the other computers

Sheet stock is also the same.

DanEpps · Post by **DanEpps** » Thu, Sep 20 2007, 5:42AM

Did you restore the eCabinets files from another computer that is working correctly?

Michael Yeargain · Post by **Michael Yeargain** » Thu, Sep 20 2007, 5:44AM

No but I will try that this weekend. Thanks for the idea. Duh

DanEpps · Post by **DanEpps** » Thu, Sep 20 2007, 5:50AM

It could be one of the dozens of settings in eCabinets and restoring will get all the files and settings. Then you know you will be on a level playing field for debugging if the issue still exists.

Michael Yeargain · Post by **Michael Yeargain** » Thu, Sep 20 2007, 5:51AM

sometimes it's the small things that get ya.