How do i fix this?

MarcoKnjaschewitsch · Post by **MarcoKnjaschewitsch** » Mon, Sep 24 2007, 1:31AM

Ok so my hinging is disappearing when i change sheet stock...So i go to door/drawer editor remove doors, re assosiate hardware and then go back out and save with new doors and the holes are there after they were \"lost\" from a sheet change...but that didn't fix it? what am i doing wrong?

Justin Melhiser · Post by **Justin Melhiser** » Mon, Sep 24 2007, 7:43AM

Could you post your file or email it to me? My email is cabinets@thermwood.com. If you need to contact me my phone number is 1-877-880-4638 ext. 227

Thank You
Justin

Forrest Chapman · Post by **Forrest Chapman** » Mon, Sep 24 2007, 8:53AM

Marco,

You may have to reassociate the holes to the hardware one time. It could be that the hardware has lost its hole patterns.

Forrest

Thermwood / eCabinet Systems

How do i fix this?

How do i fix this?