Idea for the stretcher delima (Gene)

Michael Yeargain · Post by **Michael Yeargain** » Thu, Sep 27 2007, 6:08AM

Gene, as well as others have run into this issue with the front stretchers.

This is also my preffered method of constructing my sink bases. (so many times the plumbers have ripped out our front stretchers to install the sinks.)

Idea...

Allow the stretchers to be rotated. (just like the stretcher editor)

Michael S Murray · Post by **Michael S Murray** » Thu, Sep 27 2007, 6:51AM

Michael,
YOu can turn the strechers down, this is what I do for my sink bases in frameless.

Michael Yeargain · Post by **Michael Yeargain** » Thu, Sep 27 2007, 7:31AM

I am sorry for the confusion. I was refering to the front top stretchers

Michael S Murray · Post by **Michael S Murray** » Thu, Sep 27 2007, 7:37AM

Hey Mike,
For a sink base, I just use no top and then use the up/down strecher, I also use 3/4 material for the back and this way there is nothing in the way of the sink and no carving up the cabinet to get the sink in.

Michael Yeargain · Post by **Michael Yeargain** » Thu, Sep 27 2007, 5:17PM

This may be fine except how do you get the drawer front on?

Michael S Murray · Post by **Michael S Murray** » Thu, Sep 27 2007, 5:57PM

You just screw through the strecher into the drawer stile, or wherever you like if it is a slab, built several hundred of them like this. I use the detail for kitchen, bath and commercial..I use to hate cutting the strechers out for the sink to clear..

Michael Yeargain · Post by **Michael Yeargain** » Thu, Sep 27 2007, 6:00PM

Sorry, I should have been specific.

How to you place a drawer front in the software?

Michael S Murray · Post by **Michael S Murray** » Thu, Sep 27 2007, 6:06PM

Hey Mike,
Just take it in to the drawer/door editor, light up the whole opening, the software will ignore the strecher, specify what size drawer front you want, with the correct top reveal,then check adjust bottom and uncheck add drawer, should do it, then the doors below will adjust to size according to your gap settings.

Michael Yeargain · Post by **Michael Yeargain** » Thu, Sep 27 2007, 6:16PM

Thanks Mike...Duh

Sometimes I can't see the forest for the trees..

Michael S Murray · Post by **Michael S Murray** » Thu, Sep 27 2007, 6:34PM

Yah, been there myself buddy! 6 more cabs to place, fine tune, right the twd file and go home for my favorite dinner and chair for an hour before bed!
Have a good evening..

Michael Yeargain · Post by **Michael Yeargain** » Thu, Sep 27 2007, 6:35PM

Ditto Mike, I'll be here for a quite a while tonight.

Good night.

Thermwood / eCabinet Systems

Idea for the stretcher delima (Gene)

Idea for the stretcher delima (Gene)