Side by side drawer problem

Leo Graywacz · Post by **Leo Graywacz** » Tue, Oct 02 2007, 2:07PM

I have a cabinet that has 8 sets of drawers in the center of it. 4 high by 2 wide. They are separated by a partition. I am able to add the 8 drawers using the drawer editor, but when it comes to adding the drawer fronts I can't get it done. I've added a 3/32\" face frame member between them and I can get the drawer fronts to go in. But as soon as I delete the FF member the drawer fronts go with it. How do I do this? Here is the cabinet:

DaleKern · Post by **DaleKern** » Tue, Oct 02 2007, 3:38PM

Leo,

You have a hybrid cabinet design - faceframes turned on but no faceframe between the drawers (looks like frameless). I think I would add the 3/32 faceframe and leave it - just name it \"do not cut\". I think the drawers are dependant on the faceframe and removing it disturbs the program.

Dale

Forrest Chapman · Post by **Forrest Chapman** » Tue, Oct 02 2007, 4:10PM

Leo,

I do the same thing in some instances and use a .001 face frame. You will have to leave it.

Forrest

Thermwood / eCabinet Systems

Side by side drawer problem

Side by side drawer problem