Hole Patterns.

Wally Schneeberger · Post by **Wally Schneeberger** » Sun, Nov 04 2007, 6:19PM

Do you guys with the Thermwoods use the hole patterns for the Blum Tandems or something else that doesn't have as many holes? I am looking for something in between the 2 patterns that I will post. TIA.

Gene Davis · Post by **Gene Davis** » Sun, Nov 04 2007, 6:29PM

Blum makes the product with so many holes it looks as if were shot with a goose gun.

All the competing slide manufacturers do the same. Mepla, Grass, etc. It gives you ultimate flexibility.

I engineer for the top row to be used, three screws per slide, the first at 37mm, then one midspan, the other in the rear.

Pick any three you like, but most all the makers show you where to do it in their specs. I just downloaded the latest Blum tandem 17MB brochure and specs for Tandem, but am too lazy to look at the details just now.

Brian Shannon · Post by **Brian Shannon** » Sun, Nov 04 2007, 10:51PM

Here's one that I made for Grass Elite Undermount. I think it'l work with Blum.

Brian Shannon · Post by **Brian Shannon** » Sun, Nov 04 2007, 10:57PM

Oops! I should have sent this one. I made it for Grass and Mepla.

Thermwood / eCabinet Systems

Hole Patterns.

Hole Patterns.