Carving RP-FR-MG0022

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
DanFecteau
eCabinets Beta Tester
Posts: 278
Joined: Tue, May 10 2005, 12:00PM
Location: St-Odilon, Quebec, Canada
Contact:
Contact DanFecteau

Carving RP-FR-MG0022

Post by DanFecteau »

I'd like to buy this carving but I only need the lower part of it , the \"dentell\", is ther something like this on your website ? Thanks
Top
DanFecteau
eCabinets Beta Tester
Posts: 278
Joined: Tue, May 10 2005, 12:00PM
Location: St-Odilon, Quebec, Canada
Contact:
Contact DanFecteau

Carving RP-FR-MG0008

Post by DanFecteau »

I would need to have a miror of this moulding so I would have a left and right , is it possible, I would buy both.

Thanks.
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”