2000 versus XP

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
Ian Smith
New Member
Posts: 13
Joined: Sat, Sep 03 2005, 1:41AM

2000 versus XP

Post by Ian Smith »

Hi All

Firstly would there be any benefit in reloading Thermwood control nesting onto a new drive using XP as the operating system

Secondly can this be done without having to change the motherboard

Ian
Top
Nick M Singer
Guru Member
Posts: 828
Joined: Fri, Jun 17 2005, 12:23AM
Location: South Africa

Post by Nick M Singer »

Ian I would guess that the PC in the controller is a little underspec for XP
Top
Ryan Hochgesang

Post by Ryan Hochgesang »

When wanting to run WIN XP on your Thermwood control, there is more required to system then simply loading the XP software. You must contact Thermwood's Retro/Upgrade dept. if your wanting to perform this upgrade, to ensure upgrade is handled correctly.

Thermwood Retro/Upgrade dept.:

Call: 1800 221 3865

or

email:retrofits@thermwood.com
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”