\"IT'S NOT A ROUTER, IT'S A TIME MACHINE\"

Damon Nabors · Post by **Damon Nabors** » Thu, Nov 15 2007, 1:44PM

This thing is better than an ATM MACHINE. What use to take hours has turned into minutes. All my neighbors have been wondering about my new toy and the construction or should I say Destruction of my lawn with all the electrical work going on. I told them I had a new tool coming that would save me time and money in productivity. So now they are starting to stop by to see the new toy. I had one last night that stopped in because he saw the lights were still on. He said, \"Hey, I need a cabinet down at my shop in the break room. Do you think you could work that in to your schedule this week?\" Normally I would say sure we'll see if we can work it in. But last night I was able to say would you like to wait on it. Took about 8 Minutes to cut out, a couple more to edge band, a little glue in the joints with a couple of staples and voila, Here is your cabinet. It didn't take more than 30 minutes using pre-finished plywood.

Anyway BTW, You really can't help but stand back and watch that thing cut out money and grin.

Jim Bullis · Post by **Jim Bullis** » Thu, Nov 15 2007, 2:37PM

Great story Damon, thanks for sharing!

Now, BTW...

DanEpps · Post by **DanEpps** » Thu, Nov 15 2007, 2:42PM

Jim Bullis wrote:Great story Damon, thanks for sharing!

Now, BTW...

That is a good story...why not run an article in the next member magazine about Damon's decision to buy a machine and end it with this story??

Jim Bullis · Post by **Jim Bullis** » Thu, Nov 15 2007, 2:47PM

DanEpps wrote:
Jim Bullis wrote:Great story Damon, thanks for sharing!

Now, BTW...
That is a good story...why not run an article in the next member magazine about Damon's decision to buy a machine and end it with this story??

You're not reading my mind are you, Mr Wizard?!?

DanEpps · Post by **DanEpps** » Thu, Nov 15 2007, 2:51PM

Heh, heh, heh...

Damon's subject for this thread, --\"It's not a router, it's a time machine\", would make a great story title, too.

DaleKern · Post by **DaleKern** » Thu, Nov 15 2007, 3:52PM

And it works even if you forget your PIN number...

Michael S Murray · Post by **Michael S Murray** » Thu, Nov 15 2007, 4:08PM

and then the dang payment book comes in the mail..

DanEpps · Post by **DanEpps** » Thu, Nov 15 2007, 4:41PM

Michael S Murray wrote:and then the dang payment book comes in the mail...(

Can't you just email the payments?

Damon Nabors · Post by **Damon Nabors** » Thu, Nov 15 2007, 6:24PM

I purchased ArtCam Pro also, I thought I might just make my own money.

Thermwood / eCabinet Systems

\"IT'S NOT A ROUTER, IT'S A TIME MACHINE\"

\"IT'S NOT A ROUTER, IT'S A TIME MACHINE\"

Re:

Re:

Re: