Hi
I have a tall Cabinet that i would like make a drawing, but when i take it to the line drawing editor it is to big for the page is there anyway to resize or make it fit the page.
Thank
Line Drawing
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Dickey Beckham
- Junior Member
- Posts: 58
- Joined: Sat, Aug 13 2005, 4:21PM
- Location: Arkansas
-
Todd Miller
Re: Line Drawing
Dickey,
1st - take cabinet into the Line Drawing Editor (LDE)
2nd - On the lower row of icons, select the "Cab" button. This will allow you to select the cabinet on the page.
Note: If you have an assembly on the page you will need to select "assm" button.
3rd - select the cabinet by single left clicking. The cabinet should highlight green.
4th - hold the "shift button" and both mouse buttons down at the same time. Slide the mouse front to back. This should zoom you in and out, just like in the cabinet editor.
1st - take cabinet into the Line Drawing Editor (LDE)
2nd - On the lower row of icons, select the "Cab" button. This will allow you to select the cabinet on the page.
Note: If you have an assembly on the page you will need to select "assm" button.
3rd - select the cabinet by single left clicking. The cabinet should highlight green.
4th - hold the "shift button" and both mouse buttons down at the same time. Slide the mouse front to back. This should zoom you in and out, just like in the cabinet editor.
-
Dickey Beckham
- Junior Member
- Posts: 58
- Joined: Sat, Aug 13 2005, 4:21PM
- Location: Arkansas
Re: Line Drawing
Thanks Todd
That works I have been trying to do this all day.
That works I have been trying to do this all day.
