Hi
Is there a way to angle the cornice as i have an angled unit
thanks
leigh
angle cornice
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
leigh mills
- Senior Member
- Posts: 211
- Joined: Wed, Jan 23 2008, 9:49AM
- Location: England UK
-
DanEpps
- Wizard Member
- Posts: 5852
- Joined: Thu, Jul 28 2005, 10:18AM
- Company Name: Dan Epps
- Country: UNITED STATES
- Location: Rocky Face GA
Re: angle cornice
Is the cornice added using a display panel/board? If so, select it and use the Rotate function (the curved arrow icon) to rotate it into place.
-
leigh mills
- Senior Member
- Posts: 211
- Joined: Wed, Jan 23 2008, 9:49AM
- Location: England UK
Re: angle cornice
dan i have used the molding editor
-
Kerry Fullington
- Wizard Member
- Posts: 4763
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: angle cornice
Leigh,
You can't angle a molding placed in the molding editor. You will have to delete that molding and place one manually in the cabinet Assembly editor. The molding editor molding is always going to follow the original front of the cabinet, not the angled front.
Kerry
You can't angle a molding placed in the molding editor. You will have to delete that molding and place one manually in the cabinet Assembly editor. The molding editor molding is always going to follow the original front of the cabinet, not the angled front.
Kerry
