Sloping Unit

[leigh mills]

hi guys, how does everyone go about doing sloping units? do you do these? when you take a part into part editor for example the back, there is no tools in which you can use to put a degree on the line. is the only way to chamfer the part?

Leigh

[DanEpps]

In Contour Mode of the Part Editor you can set Angle Snap to any degree that you need and lines will be drawn only in incremennts of the angle.

[Damon Nabors]

Leigh, go to search and look up "sloped roof cabinet" I think this is what you are talking about. I would have posted the link but I have not figured out how to do this. Maybe Dan or someone can post it.

[DanEpps]

How 'bout if I tell you how to post the link? Just click in the address bar of your browser and copy the URL (ctrl-c) to the clipboard. Then in your reply, ctrl-v will paste the URL.

If you want the URL to be hidden and display a text link, select the URL you just pasted and click the URL button above. Then you do a little editing--change the 1st occurance of ] to =. Go the the end of the URL, just before the next occurance of [ and enter ]text you want displayed.

You link, before posting should look like (spaces inserted so it will display text instead of a link):
[ URL = http://www.whatever.com]Text to display[ / URL]

[Damon Nabors]

here

Thanks Dan for the info.

[DanEpps]

Thanks Dan for the info.

Give a man a fish, feed him for a day, teach a man to fish...

[Forrest Chapman]

....they won't show up for work!

[George Davidson]

Hi Leigh
I am making a miter box bench with a sloding bottom rail

[DanEpps]

That floor running downhill like that must make it very hard to stay level-headed at work...

[George Davidson]

The bench is all most 12' long it drops 2-7/8"
I was thing about just doing sloping Cabinets