Measurement nodes on part editor cuts
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
Measurement nodes on part editor cuts
Don't know if this has been asked but here goes, After I have taken any particular part to the part editor and created a cutout when I bring it back to the main the measurement tool won't recognize the cutout and same in the line drawing editor. Is this something that could be possible? Mark. Outlaw Carpenters 2009
-
Justin Melhiser
Re: Measurement nodes on part editor cuts
Mark
Are you using a part out of a cabinet or display panels and boards? The display panels and boards do not have this capability as ov right now. I spoke with the programmers and they are going to add it to the list of things. You can take them to the LDE and apply deminsions to the cut out. Now in the main cabinet editor you can load a cabinet and delete everything ecept for the back, apply your cut out. Now you can use the deminsion icon and measure the cut out. you can also now have a panel that you can resize with the cut out in it. I hope this will help you.
Are you using a part out of a cabinet or display panels and boards? The display panels and boards do not have this capability as ov right now. I spoke with the programmers and they are going to add it to the list of things. You can take them to the LDE and apply deminsions to the cut out. Now in the main cabinet editor you can load a cabinet and delete everything ecept for the back, apply your cut out. Now you can use the deminsion icon and measure the cut out. you can also now have a panel that you can resize with the cut out in it. I hope this will help you.
Re: Measurement nodes on part editor cuts
Thanks Justin I'll give that a try. Mark