And while we are on the subject can we add our own doors into the system?
knocking on the door
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
David Bouchette
- New Member
- Posts: 7
- Joined: Tue, Feb 26 2008, 11:07AM
knocking on the door
Can we change material on doors to other than what is provided? I have added material in and can't get the same materials to build any of the doors with
And while we are on the subject can we add our own doors into the system?
And while we are on the subject can we add our own doors into the system?
-
Justin Melhiser
Re: knocking on the door
David
When you add the material to your data base, did you add it as sheet stock? Once this material is added you load a cabinet and select the door/drawer editor. Once in here click on the door/ drawer selection. You then select either MDF or Slab doors. This will allow you to select the material from your sheet stock. Once you have everything selected you click on the set as default. Then you can add your door. You can create your own doors in the door designer. If you have a certain profile that goes on the inside of the door then you would need to draw that shape up in the shape manager. Once that is done you will save that as a tool. Then go into the door designer and select MDF door and pick the sheet stock. Now there are three tabs at the top that say main, tools, and layout. You will next pick the tools for the inside profile and outside profile. This will be the tool you drew in the shape manager. Then you can click on the layout tab and make adjustments to your door. I suggest going over the door designer part of the manual before diving right in to the door designer. If you have any more questions feel free to ask.
When you add the material to your data base, did you add it as sheet stock? Once this material is added you load a cabinet and select the door/drawer editor. Once in here click on the door/ drawer selection. You then select either MDF or Slab doors. This will allow you to select the material from your sheet stock. Once you have everything selected you click on the set as default. Then you can add your door. You can create your own doors in the door designer. If you have a certain profile that goes on the inside of the door then you would need to draw that shape up in the shape manager. Once that is done you will save that as a tool. Then go into the door designer and select MDF door and pick the sheet stock. Now there are three tabs at the top that say main, tools, and layout. You will next pick the tools for the inside profile and outside profile. This will be the tool you drew in the shape manager. Then you can click on the layout tab and make adjustments to your door. I suggest going over the door designer part of the manual before diving right in to the door designer. If you have any more questions feel free to ask.