I am still having the problem way too often of full dadoes not being cut all the way to the end of the shelf or partition that slides into it.
I don't have this problem on blind dadoes just full dadoes. This is the dado in either the back or deck on partitions, and the left and right end on fixed shelves.
I have been dealing with this problem for at least six months and can't seem to get it figured out.
It takes long enough to draw a job in ecabs, never mind to write down each step you take in drawing a 30-50 sheet job so I don't know how to get it reproduced by the folks at thermwood.
Anybody else having this problem. Please help if possible!
Dados nor being cut all the way to the end
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Mike Snodgrass
- Junior Member
- Posts: 70
- Joined: Mon, Nov 28 2005, 10:12PM
- Location: LUBBOCK, TX
-
Justin Melhiser
Re: Dados nor being cut all the way to the end
Mike
Please send me this job you are working. Are they not showing up in ecabinets or out at the control. If you can have Grady send me his export file. I will see what I can do for you.
Please send me this job you are working. Are they not showing up in ecabinets or out at the control. If you can have Grady send me his export file. I will see what I can do for you.