edge detail
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
michael taylor
- New Member
- Posts: 15
- Joined: Wed, Jan 09 2008, 2:35PM
edge detail
its kind of hard to explain without showing a picture but a client wants a cabinet built with the top rail of an upper having little round edges across the bottom kind of like saw teeth but round. it is driving me crazy trying to design the picture for them. if anyone has advice please help. it is 50 inches wide and 10inches tall. thanks mike
-
michael taylor
- New Member
- Posts: 15
- Joined: Wed, Jan 09 2008, 2:35PM
Re: edge detail
i didnt clarify that it is a faceframe cabinet. the top rail of the faceframe, they want the bottom edge of that rail to have the little rounded teeth detail. it is an open bookcase. i have been trying to mess with it in part editor and i can cut the circles out of the board but i cant cut them the other way. any suggestions.
-
Justin Melhiser
Re: edge detail
Michael
Do you have the geometry from these cut outs? If so could you send it to me. If you do not have them, if you have a diagram or the dimensions on what they need to be, you can send it to me and I could give you a call to help you with getting this drawn up.
Do you have the geometry from these cut outs? If so could you send it to me. If you do not have them, if you have a diagram or the dimensions on what they need to be, you can send it to me and I could give you a call to help you with getting this drawn up.
