Create a round part

[Patrick Russell]

I'm tring to create a round part using part editor, but only can do round holes. How does one create a round part, for example a table top?

[David Hall]

Draw your circle in the "Contour" section of the part editor
Exit contour mode.
Select "Create part using closed contour" from the right click menu.
click on the circle.
Click on "Next" button at bottom of screen.

Regards,
Dave

[Patrick Russell]

Thank you David

Draw your circle in the "Contour" section of the part editor
Exit contour mode.
Select "Create part using closed contour" from the right click menu.
click on the circle.
Click on "Next" button at bottom of screen.

Regards,
Dave