Any chance we could get Scrap part recovery to recognize profile modeling?
Right now, profile modeling is ignored if you select scrap part recovery.
Regards,
Dave
Scrap Part Recovery and Profile modeling
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
David Hall
- eCabinets Beta Tester
- Posts: 593
- Joined: Tue, May 17 2005, 12:41PM
- Location: Stamford, CT USA
- Contact:
-
Justin Melhiser
Re: Scrap Part Recovery and Profile modeling
David
I will send this over to the programmers and see what they think.
I will send this over to the programmers and see what they think.
