Was wondering if you guys at Thermwood had the intergraton of a part editor into the drawer box designer on your list of priorities ?
Dale
Drawer box designer question
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Dale Wills
- Senior Member
- Posts: 190
- Joined: Mon, Oct 10 2005, 11:09PM
- Company Name: none
- Country: AUSTRALIA
- Location: Camperdown, Victoria, Australia
-
Scott G Vaal
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: Drawer box designer question
Dale,
We certainly have this functionality on the list. But, with that said, we cannot give you any specifics at this time as to exactly when it will be implemented.
We certainly have this functionality on the list. But, with that said, we cannot give you any specifics at this time as to exactly when it will be implemented.
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000