syntax error

Joe Dougherty · Post by **Joe Dougherty** » Tue, May 06 2008, 2:09PM

all of a sudden I am getting syntax error "measurements must be in 1/32" and when I return to the main area half of my partition disappears.

Rick Palechuk · Post by **Rick Palechuk** » Tue, May 06 2008, 2:16PM

I got the same error on insetting the front of a fixed shelf.

Joe Dougherty · Post by **Joe Dougherty** » Tue, May 06 2008, 2:24PM

This does happen in the shelf and partition area. I do not have any insets for my cabinet shelf. But the error shows two times when I try to leave the construction settings in the shelf and partition area.

Joe Dougherty · Post by **Joe Dougherty** » Wed, May 07 2008, 7:47AM

Since a couple of us are getting this error "measurements must be in 1/32 increments" does anyone think this could be a bug? Hopefully, one of the software experts could shed some light on this error, did not get this in previous version.

Justin Melhiser · Post by **Justin Melhiser** » Wed, May 07 2008, 8:53AM

Joe
This is being looked into. I have noticed that it will give you the error message but the part will come out the way it should. If you see that your parts are not, please let me know asap.

JohnLashuay · Post by **JohnLashuay** » Tue, Jun 03 2008, 3:44PM

Has there been any new info on this error?

I am not having any problems with it other than it being a bit of a nuisance.

John

Justin Melhiser · Post by **Justin Melhiser** » Wed, Jun 04 2008, 1:51PM

John
There is no word on this yet. I will let you know as soon as I know something.

JohnLashuay · Post by **JohnLashuay** » Wed, Jun 04 2008, 4:11PM

Thanks Justin

Thermwood / eCabinet Systems

syntax error

syntax error

Re: syntax error

Re: syntax error

Re: syntax error

Re: syntax error

Re: syntax error

Re: syntax error

Re: syntax error