Was wondering what your guys out there do for 'cut and edge' services that you may offer? Do you input the cut lists in eCabinets through batch cabinets with panels that have edging specified? Do you use a cabinet end for this with the approapriate edges assigned with edgetape? Ultimately we want the parts to come off the table with the lables showing the part size and what edges get edged. What approached do you guys take here?
Dale
CUT AND EDGE SERVICES
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Dale Wills
- Senior Member
- Posts: 190
- Joined: Mon, Oct 10 2005, 11:09PM
- Company Name: none
- Country: AUSTRALIA
- Location: Camperdown, Victoria, Australia
-
Justin Melhiser
Re: CUT AND EDGE SERVICES
Dale
When you create a cabinet with edge banding on it, the control will print out a label wit the cabinet name, cabinet part, and the edge that will get banding on it. The size of that part will print out on the nest sheet, not the label.
When you create a cabinet with edge banding on it, the control will print out a label wit the cabinet name, cabinet part, and the edge that will get banding on it. The size of that part will print out on the nest sheet, not the label.