Parts Editor

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Dickey Beckham
Junior Member
Posts: 58
Joined: Sat, Aug 13 2005, 4:21PM
Location: Arkansas

Parts Editor

Post by Dickey Beckham »

Hi,
I need to make a pie shape piece of 1/4 glass, 11.75 x 11.75 with a rounded front, I have tryed to take a Display Board
into Part editor to cut out using the fillet ,But it will not let me select but on edge. Is there anyway that this can be done.
the glass will be used as a inlay for corner shelve cabinet, Thanks for any help.
Top
User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Re: Parts Editor

Post by DanEpps »

Use the three-point arc in Contour Mode of the Part Editor to create the curve.
Top
User avatar
Damon Nabors
eCabinets Beta Tester
Posts: 923
Joined: Wed, Apr 05 2006, 5:50PM
Location: Marion, Ar.
Contact:
Contact Damon Nabors

Re: Parts Editor

Post by Damon Nabors »

Dickey, Here you go.
Attachments
pie shaped glass.hsf
(16.02 KiB) Downloaded 310 times
Damon Nabors
Top
Dickey Beckham
Junior Member
Posts: 58
Joined: Sat, Aug 13 2005, 4:21PM
Location: Arkansas

Re: Parts Editor

Post by Dickey Beckham »

Thanks for the Help :beer:
Top
Post Reply

Return to “eCabinet Systems Software”