resize problem after updating

[jose_martinez]

Hi,

I having problem resizing the cabinets I already have on my library.

I have a library of standard framless, full dado cabinets, I have been using for a while now without problems, but today I try to change the Cabinet width withing the cabinet editor, and also in the install area of the floor layout and I keep getting this error message "Construction settings on this cabinet cause a part to be cut in two. Please check your tenon settings and try again." Withing the construction settings of the cab I don't have any tenon settings define, they are all blank.

Can some one please explain me where is my error, I am not a design expert, I don't even understand to much about the tenon settings, I have never touch that settings before.

Thanks, Jose

[Walker T Scott]

Jose

Post the cabinet and will take a look at it.

[jose_martinez]

sorry for the late reply, been busy

I can post one of the cabs, but it's happening with all the cabinets i have on my libraries, for the current project I just decide to make a new library and start from scratch and it appears to be working. I ,think, I post the one of the cabs I was using, never upload before, If anyone can help me before I have to remake all my libraries, i will be very happy

Thanks.

[Rick Palechuk]

Jose, you have Full Dado selected for the deck, fixed shelf and partition which was cutting through the back. I just removed the back, then it allowed me to resize.