Nesting output

[Neal Meyers Jr]

I have been working on a bath vanity built in and when I try to nest the cabinets I do not get any out put to my screen. I was able to get it to nest one time but most of the diagrams were up behind the menu bar. Now I get nothing but a momentary flash on the screen but I do not know what it is saying.

Any help is welcome.
Neal Meyers Jr
Euharlee Woodshop
White Ga.

[Justin Melhiser]

Neal
When you say nest, are you talking about at the CNC machine or in eCabinets? Please send me your files and I will take a look at it.

[Jason Susnjara]

Hi Neal,

You must make sure that you have the vanity cabinet or any other cabinet is placed either in the room layout or batch area.

[Neal Meyers Jr]

Thank you I did not have it in the batch area or the layout area. I was trying to nest it from the Cabinet editor.
I ran it from the batch layout area and it worked just fine.

Thank you again.
Neal Meyers Jr
Euharlee Woodshop
White, Ga.

PS once I have the built in completed in eCabinets I will post it here in the Forum.