edgebanding

Brent Pister · Post by **Brent Pister** » Thu, Oct 30 2008, 10:18PM

I cannot get eCabs to display any edgebanding. The edgebanding function was running very slow and now will not display the banding at all. At times eCabs will shut down completely during the task. I don't know if it is the program, my system or something I am doing wrong. Can anyone shed any light?

Thanks
Brent

Walker T Scott · Post by **Walker T Scott** » Fri, Oct 31 2008, 5:49AM

Brent

Post the job and we will take a look at it.
Thanks

Justin Melhiser · Post by **Justin Melhiser** » Fri, Oct 31 2008, 7:23AM

Brent
What are the specs on your computer? Please include the graphics card information. You can post them here or email them to me.

Gary Puckett · Post by **Gary Puckett** » Fri, Oct 31 2008, 7:32AM

Speaking of edge banding when I go to edge band I get a message that says ( could not find J peg file) I click my mouse about 20 times and the part gets the edge band. What is going on with that?

Gary

Justin Melhiser · Post by **Justin Melhiser** » Fri, Oct 31 2008, 7:36AM

Gary
Is this with every cabinet or just certain ones?

Gary Puckett · Post by **Gary Puckett** » Fri, Oct 31 2008, 7:37AM

every cabinet I just tried it

Justin Melhiser · Post by **Justin Melhiser** » Fri, Oct 31 2008, 7:38AM

Gary
Are the images you add to the edgebanding ones that you created or ones that were already installed with the software?

Gary Puckett · Post by **Gary Puckett** » Fri, Oct 31 2008, 7:45AM

Justin,

They are the ones in the software

Gary

Justin Melhiser · Post by **Justin Melhiser** » Fri, Oct 31 2008, 8:19AM

Gary
What are the settings and name for the edgebanding you are trying to add. Is it on any edgebanding or just certain banding material. Please post them here or email them to me.

Thermwood / eCabinet Systems

edgebanding

edgebanding

Re: edgebanding

Re: edgebanding

Re: edgebanding

Re: edgebanding

Re: edgebanding

Re: edgebanding

Re: edgebanding

Re: edgebanding