Hey How's it going?
Question. In 5.42 in nesting parameters with starting corner Lower left is where on the machine? Is it from looking @ the machine side of things or from standing in front of it @ the vaccum handle end?
Thanks
Thom Davies
CN 5.42
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Thom Davies
- Guru Member
- Posts: 530
- Joined: Tue, May 17 2005, 6:44PM
- Company Name: Dawn Group
- Country: NEW ZEALAND
- Location: Christchurch New Zealand
-
Paul Ford
- eCabinets Beta Tester
- Posts: 632
- Joined: Wed, May 18 2005, 1:18AM
- Location: Rotorua - NewZealand
Re: CN 5.42
Hey Thom,
I'm pretty sure lower left is looking from the machine side, so it would be the same place as your G901 position.
Paul.
I'm pretty sure lower left is looking from the machine side, so it would be the same place as your G901 position.
Paul.
-
Gary Urlacher
- Junior Member
- Posts: 76
- Joined: Mon, Jun 02 2008, 11:39AM
Re: CN 5.42
Is there an updated manual for 5.42? I have some questions about the new features and I thought I would look at the manual
prior to asking.
Gary
prior to asking.
Gary
-
Daniel Vonderheide
- Thermwood Team
- Posts: 361
- Joined: Wed, May 17 2006, 11:25AM
- Location: Thermwood
Re: CN 5.42
Gary
when you installed CN v5.42, you also installed the latest manual. On the main screen of CN, there is a small blue box with a question mark in it. This is the link to the manual.
when you installed CN v5.42, you also installed the latest manual. On the main screen of CN, there is a small blue box with a question mark in it. This is the link to the manual.
