Problem nesting a job

DanFecteau · Post by **DanFecteau** » Mon, Dec 08 2008, 8:27AM

I upgraded to RN 5.44. I have a job that I was able to cut all my materials but one when I use the material filter and I get this message when I try to nest this material alone : "Not a valid password". If I nest the whole job I get : "Getrows binding error. Probably caused by datatype mismatch."

I attached the .twd.

Thank you.

Justin Melhiser · Post by **Justin Melhiser** » Mon, Dec 08 2008, 8:56AM

Dan
Does this job have doors and drawer fronts in it? If so, did you group them?

DanFecteau · Post by **DanFecteau** » Mon, Dec 08 2008, 9:11AM

Yes it does have doors and they are grouped

DanFecteau · Post by **DanFecteau** » Mon, Dec 08 2008, 10:03AM

Is another job problem. I get : "Error opening Nestlib. Exiting..."

Justin Melhiser · Post by **Justin Melhiser** » Tue, Dec 09 2008, 8:24AM

Dan
If your still having problems after our phone conversation yesterday, please let me know.

DanFecteau · Post by **DanFecteau** » Tue, Dec 09 2008, 8:42AM

I got back to 5.41 so now I'm ok, waiting for 5.45

Thermwood / eCabinet Systems

Problem nesting a job

Problem nesting a job

Re: Problem nesting a job

Re: Problem nesting a job

Re: Problem nesting a job

Re: Problem nesting a job

Re: Problem nesting a job