2 pices can fit on one 49 x 97 sheetBar counter top
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
George Davidson
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
Bar counter top
It looks like it will cut out on a CNC router.How would I get to cut 2 pices out of one sheet 2 pices can fit on one 49 x 97 sheet
2 pices can fit on one 49 x 97 sheet- Attachments
-
- Counter Top_1.jpg (54.59 KiB) Viewed 2931 times
-
- Counter Top_2.jpg (67.06 KiB) Viewed 2930 times
-
- Counter Top_3.jpg (40.53 KiB) Viewed 2930 times
-
Damon Nabors
- eCabinets Beta Tester
- Posts: 923
- Joined: Wed, Apr 05 2006, 5:50PM
- Location: Marion, Ar.
- Contact:
Re: Bar counter top
George,
Are you trying to cut the two pieces that are on the top nest? I don't see how you are going to get both of those to nest on one sheet.
Are you trying to cut the two pieces that are on the top nest? I don't see how you are going to get both of those to nest on one sheet.
Damon Nabors
-
George Davidson
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
Re: Bar counter top
Hi Damon
I would like to do the 2 pices of Wilsonart on one sheet
I would like to do the 2 pices of Wilsonart on one sheet
- Attachments
-
- Counter Top_4.jpg (34.22 KiB) Viewed 2908 times
-
- Counter Top_5.jpg (18.86 KiB) Viewed 2907 times
-
Damon Nabors
- eCabinets Beta Tester
- Posts: 923
- Joined: Wed, Apr 05 2006, 5:50PM
- Location: Marion, Ar.
- Contact:
Re: Bar counter top
George,
If they both fit on a single sheet. Draw them up as a dxf file with both of them on one sheet and then open the dxf file in the parts editor onto a sheet of material and it should nest that way.
If they both fit on a single sheet. Draw them up as a dxf file with both of them on one sheet and then open the dxf file in the parts editor onto a sheet of material and it should nest that way.
Damon Nabors