Dimentioning

Gary Puckett · Post by **Gary Puckett** » Mon, Jan 05 2009, 10:21AM

This may have been asked before, but I'll ask one more time.

Is ther any way to select the line when dimentioning a cabinet, rather than the node? ( In the line drawing editor )

Hopefully this will be one of the updates.

Gary

Todd Miller · Post by **Todd Miller** » Mon, Jan 05 2009, 10:29AM

Gary,
At this time the nodes are the only pickable points for dimensioning.

Gary Puckett · Post by **Gary Puckett** » Mon, Jan 05 2009, 10:33AM

Do you know if this is being considered?

Gary

Todd Miller · Post by **Todd Miller** » Mon, Jan 05 2009, 10:41AM

Gary,
I do not.

Gary Puckett · Post by **Gary Puckett** » Mon, Jan 05 2009, 11:01AM

Todd,

Can you find out?

Todd Miller · Post by **Todd Miller** » Mon, Jan 05 2009, 11:05AM

Gary,
No this has not been considered. You may want to put in a request through the software, so that our programmers know about it. Thanks

Thermwood / eCabinet Systems

Dimentioning

Dimentioning

Re: Dimentioning

Re: Dimentioning

Re: Dimentioning

Re: Dimentioning

Re: Dimentioning