Need some information

Gary Puckett · Post by **Gary Puckett** » Wed, Jan 28 2009, 12:33PM

I am having a hard time creating a bead tool, I create the tool, saved the tool in my profile tool folder but when I try to use the tool it's not there.

I have created a tool before and it worked just fine. I must be doing something wrong and I can't figure it out.

Thanks
Gary

DanEpps · Post by **DanEpps** » Wed, Jan 28 2009, 12:45PM

What are you doing, step-by-step?

What folder are you saving the tool in? Are you looking for the tool in the same folder?

Have you searched the hard drive for the file name of the tool?

Gary Puckett · Post by **Gary Puckett** » Wed, Jan 28 2009, 1:03PM

Hi Dan,

1) Create a .500 bead tool making sure I am at X 0 Y 0

2) It ask for a dia. for the tool I tell it .500

3) I save the tool in " my profile tool folder"

When I go to my computer/Thermwood/ecabinets/my profile tool I see the saved tool and it has the ecabinet symbol in front of it.

When I try to use the tool the system will not show the tool and it closes. This is the only tool this happens to

Gary Puckett · Post by **Gary Puckett** » Wed, Jan 28 2009, 1:21PM

OK I just did everything all over again and this time it took. Go figure

Gary

DanEpps · Post by **DanEpps** » Wed, Jan 28 2009, 1:35PM

Weren't holding your mouth right.

Gary Puckett · Post by **Gary Puckett** » Wed, Jan 28 2009, 1:56PM

There ya go

Thermwood / eCabinet Systems

Need some information

Need some information

Re: Need some information

Re: Need some information

Re: Need some information

Re: Need some information

Re: Need some information