Hi Guys,
I couldn't seem to see these hex bolts about 74mm long with 4mm thread on one end and a threaded hole the other in the Thermwood shop.
We pushed a bit of board into the tool change last week which pushed over 4 holders.
I need about 8 plus a few spares.
If the freight blows the cost out of the water can I make my own? Do I have to do them in segments like the originals or in one length.
Thanks
Neville
Tool holder hex bolt supports
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Neville Bastian
- Guru Member
- Posts: 622
- Joined: Fri, May 20 2005, 6:48PM
- Company Name: Classic Cabinetry
- Location: Albany Western Australia
- Contact:
Tool holder hex bolt supports
Neville Australia
-
Todd Miller
Re: Tool holder hex bolt supports
Neville,
I would say you could find something that would work. But you will probably need to reset the tool pick-up locations. You should contact our service department and tell them what you need.
The number is 1-800-221-3865
I would say you could find something that would work. But you will probably need to reset the tool pick-up locations. You should contact our service department and tell them what you need.
The number is 1-800-221-3865
