Dont want drawerboxes in the cutlist

[Steve Williams]

Hello All

I outsource my drawer boxes, but place them so the cnc can bore the holes for the slides.
In the same way that my outsourced doors dont show on the cut list, is there something similar for the drawer boxes?
Thanks
Steve

[Nemanja Vujkovic]

Steve,
you do not have to place drawer boxes for the CNC to bore the holes for the slides. You can set up so the holes get bored with the drawer front. Drawer front and doors can be made out of material that's differnt from the cabinet so they can be easily filtered out from the nest.

Nemanja

[Steve Williams]

Thanks Nemanja

Where would associate the holes to the drawer front?
The Hardware Hole Editor?

Steve

[Nemanja Vujkovic]

Steve,
go to door/Drawer Editor and go to Hardware Selection. Pick the slide that you need and associate a hole pattern. After you do that, click on Set as Default Drawer (not Drawer Box) and you are set.

Nemanja

[Steve Williams]

Thanks Nemanja

I always wondered what that was for

Steve