Cannot Find Selected Part

Leo Graywacz · Post by **Leo Graywacz** » Sat, Apr 11 2009, 12:21PM

I have a lazy susan cabinet that I have a furniture toekick on. When I modified the toekick to be 1" taller something went wrong. All was fine at the begining and after I tweaked it a few times I noticed that the toekick had changed. The rounded part is suppose to be close to the straight 1" rail. But it has shifted down by what looks like 1". So I went to take it into the confinement manager and got the message that it couldn't find the selected part. I went into the parts editor and it found the part no problem. I got rid of the doors and tried again but it was not found. It is not imperative that I modify this cabinet to look normal, but it would be nice. I have attached the cabinet. Hopefully someone can figure out how I can fix it without remaking the cabinet.

Gary Puckett · Post by **Gary Puckett** » Sat, Apr 11 2009, 1:23PM

Leo,

I tried to down load the cabinrt 2 times and each time all I get it the lazy susan part

Gart

Leo Graywacz · Post by **Leo Graywacz** » Sat, Apr 11 2009, 1:40PM

I just downloaded it and it worked fine. I got the cabinet, it just didn't have a picture associated with the file. Do you mean you only got the rotating plastic lazy susan part?

Leo Graywacz · Post by **Leo Graywacz** » Sat, Apr 11 2009, 1:46PM

Sent the file to your email address listed here. Maybe it'll work by going that route. Thanks.

George Davidson · Post by **George Davidson** » Sat, Apr 11 2009, 3:26PM

I could not fix your legs

I made DXF for you if this is what you are looking for

Thermwood / eCabinet Systems

Cannot Find Selected Part

Cannot Find Selected Part

Re: Cannot Find Selected Part

Re: Cannot Find Selected Part

Re: Cannot Find Selected Part

Re: Cannot Find Selected Part