carving library?

Michael S Murray · Post by **Michael S Murray** » Wed, Apr 15 2009, 12:29PM

I thught I had read in one of the posts a responce from Ken S. that the carving library would be reintroduced in this latest release. I am not seeing it in any of the downloads, am I missing it or does any one have any info about this. I am getting ready to do a kitchen very soon and the owner would like some carvings incorporated in a couple valances and decorative trim pcs.

DanEpps · Post by **DanEpps** » Wed, Apr 15 2009, 12:42PM

Take a look here Mike.

Jody Wilmes · Post by **Jody Wilmes** » Mon, Apr 20 2009, 10:14AM

Be sure to download the latest update for your controller. The update has all the "rental" stuff stripped out and no longer requires account setup.

The update can be found HERE under "Setup Information."

Michael S Murray · Post by **Michael S Murray** » Mon, Apr 20 2009, 10:19AM

Thank you Gentelman..

Thermwood / eCabinet Systems

carving library?

carving library?

Re: carving library?

Re: carving library?

Re: carving library?