constriant manager

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
BenRatt
Senior Member
Posts: 170
Joined: Sat, Oct 22 2005, 10:59AM
Location: Spartanburg, SC
Contact:
Contact BenRatt

constriant manager

Post by BenRatt »

Is there a way to keep holes centered in a panel with the constraint manager? For instance holes for 4" wire pulls for a drawer front? This way if the width or height of the drawer front was changed it would keep those holes centered top to bottom and left to right.
Ben Ratterree
Blue Ridge Cabinetworks
Spartanburg, SC
http://www.blueridgecabs.com
Top
User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Re: constriant manager

Post by DanEpps »

See this thread Ben...is has exactly what you need:

http://www.thermwood.com/forums/viewtop ... f=3&t=9172
Top
Post Reply

Return to “eCabinet Systems Software”