Wall Views not Consistant

Rob Perry · Post by **Rob Perry** » Fri, May 15 2009, 12:09PM

Hi All

I just started working on a project & First I added windows & Doors to the walls.

Then I proceed to make a couple cutouts in one wall But when in Wall Cutout screen the wall in question is viewed from the Back But in the place door/Window screen it is viewed from the front.

It makes it very confusing when trying to make the cutouts from the Back of the wall. Should these not both be viewed from the front?

I have never noticed this issue before.

Am I doing something wrong?

Al dedenus · Post by **Al dedenus** » Fri, May 15 2009, 7:32PM

You didn't by any chance change the build direction before you went to make your cutout

Rob Perry · Post by **Rob Perry** » Fri, May 15 2009, 9:48PM

Al dedenus wrote:You didn't by any chance change the build direction before you went to make your cutout

Nope..

Al dedenus · Post by **Al dedenus** » Sat, May 16 2009, 1:26AM

Post your job Rob so the wizards can have a look.It will give them something to do over the weekend

I've not had this problem and yes both should be viewed from the front

Gary Puckett · Post by **Gary Puckett** » Sat, May 16 2009, 9:41AM

When you are in wall view/ elevation make sure the wall view section on the left says front

Gary

Rob Perry · Post by **Rob Perry** » Tue, May 19 2009, 5:54PM

oops !! I forgot about posting the job file. I'll try to post it soon.
I've actually noticed this on another job I am working right now as well.
I do remember when laying out the walls on my current job I had to change build direction of one wall in and when attempting a cutout it to is backwards but only when in wall cutout mode.

Thermwood / eCabinet Systems

Wall Views not Consistant

Wall Views not Consistant

Re: Wall Views not Consistant

Re: Wall Views not Consistant

Re: Wall Views not Consistant

Re: Wall Views not Consistant

Re: Wall Views not Consistant