how to create in ecabinets

[mohan kommineni]

we are trying to make few bases which are round. how to construct round base of 500 diameter is there any option to do in cabinets i tried to do it by taking a square and fillet it in cabinet editor but failed it doesnt allow 4th side filet got stuck,anyone had tryed to create round base pls suggest

[Nick M Singer]

It should be very easy to do in the part editor, use the "contour" icon and create an arc or circle there by selcting the circle/arc icon. Afterwards you can create a part using a closed contour.

[Ryan Hochgesang]

For future reference, this posting would be best located under the eCabinet section of the forum. This would allow more communication with those who are specifically using eCabinets.

Link:

http://www.thermwood.com/forums/viewforum.php?f=3


Thank you!

[mohan kommineni]

It should be very easy to do in the part editor, use the "contour" icon and create an arc or circle there by selcting the circle/arc icon. Afterwards you can create a part using a closed contour.

hi nick
thanks for giving the hint that helped me.

[mohan kommineni]

For future reference, this posting would be best located under the eCabinet section of the forum. This would allow more communication with those who are specifically using eCabinets.

Link:

http://www.thermwood.com/forums/viewforum.php?f=3


Thank you!

i agree with u ryan i request the admin to take a chance and move the post to relevant section

Thank you