Machining solid arborite 3/8" thick

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
DanFecteau
eCabinets Beta Tester
Posts: 278
Joined: Tue, May 10 2005, 12:00PM
Location: St-Odilon, Quebec, Canada
Contact:
Contact DanFecteau

Machining solid arborite 3/8" thick

Post by DanFecteau »

I have a lot of solid arborite 3/8" thick to machine. Pieces are kind of small in width (2 1/4") and will machine approximatly 20 000 ft a year so I want to know what do you guy use to machine this. I will also need to drill holes 3mm or 4mm so need help for this too ! Thank you very much.
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”