I find myself needing to draw a little cubby under a staircase - the back wall of this cubby is 52.25" tall, then the wall breaks over at a 135 degree angle and becomes a Wall and/or ceiling
. How can get such a thing to render in my job?Area under Staircase - Sloping Wall or Ceiling
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Rob Babcock
- Junior Member
- Posts: 33
- Joined: Wed, Jun 21 2006, 4:51PM
Area under Staircase - Sloping Wall or Ceiling
Things are slow, so I'm trying once more to ramp up on eCabs...
I find myself needing to draw a little cubby under a staircase - the back wall of this cubby is 52.25" tall, then the wall breaks over at a 135 degree angle and becomes a Wall and/or ceiling. How can get such a thing to render in my job?
I find myself needing to draw a little cubby under a staircase - the back wall of this cubby is 52.25" tall, then the wall breaks over at a 135 degree angle and becomes a Wall and/or ceiling
. How can get such a thing to render in my job?-
DanEpps
- Wizard Member
- Posts: 5852
- Joined: Thu, Jul 28 2005, 10:18AM
- Company Name: Dan Epps
- Country: UNITED STATES
- Location: Rocky Face GA
Re: Area under Staircase - Sloping Wall or Ceiling
Use a Display Cube and make the angles in the Part Editor. Save it as an assembly and install it into the room.