Fixed shelf protruding from cabinet

Donald Thomson · Post by **Donald Thomson** » Tue, Jul 14 2009, 7:19PM

I'm trying to get the fixed shelf in the attached cabinet to be flush with the back and front of the cabinet. But it seems to be protruding from the back by a little bit. The cabinet side is 15.5" and the shelf is 15.536". I know I'm missing something here, just don't know what?

Damon Nabors · Post by **Damon Nabors** » Tue, Jul 14 2009, 8:53PM

I noticed you also have a gap on the right side of the shelf, I went about it a little different than you, but I corrected that problem as well.
Hope this will help you

Donald Thomson · Post by **Donald Thomson** » Tue, Jul 14 2009, 11:26PM

Thank you Damon!

I'll take a look at how you approached it.

Donald Thomson · Post by **Donald Thomson** » Thu, Jul 16 2009, 1:18PM

Hi Damon,

Thank you again for your help. When I try to load the cabinet I get an error dialog that says:

"The requested change resulted in an unworkable dimension for this cabinet. Press OK to restore previous settings"

When I click OK I get a cabinet that looks like the attached JPG file. Not sure what I'm doing wrong.

Thermwood / eCabinet Systems

Fixed shelf protruding from cabinet

Fixed shelf protruding from cabinet

Re: Fixed shelf protruding from cabinet

Re: Fixed shelf protruding from cabinet

Re: Fixed shelf protruding from cabinet