I searched the forum but couldn't successfully find the answer to this probably often asked question: I am several versions behind on Control Nesting so can I just go to the latest version and download it or do I need to get the interim versions loaded as well? My impression is I can just load the latest and all will be well with the world but before I fix something that isn't broken, I want to make certain. My reluctance to update is that all was running really well but now we have some pocketing issues and I read that newer versions addressed some of these. I will be going from 5-41 to 5-48
Thanks in advance for the answer.
Update Control Nesting
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Ryan Hochgesang
Re: Update Control Nesting
Hi Rob,
Yes, you can just go to the Control Nesting update site and download the latest update version, save it to your control, then run the update to bring your control nesting software up to the latest version. It is not necessary to have all the in between updates to make the latest version install properly.
Yes, you can just go to the Control Nesting update site and download the latest update version, save it to your control, then run the update to bring your control nesting software up to the latest version. It is not necessary to have all the in between updates to make the latest version install properly.