![Question :?:](./images/smilies/icon_question.gif)
![Question :?:](./images/smilies/icon_question.gif)
These are furniture-style cabinets with 5" wide bottom rails, and I specify a colonial base molding for the bottom. Miter joints left and right with no scribes to begin (all 0").
If I forget to change the distance-to-top&bottom dimensions it gets placed around the top of the cabinet, with all three sides flush up against the cabinet.
![Frustrated :wall:](./images/smilies/pictowallsmall.gif)
![Frustrated :wall:](./images/smilies/pictowallsmall.gif)
If I do set the distance-to-bottom as 0", the molding gets placed around the bottom of the cabinet, but with the front piece 3/4" away from the front (gap in between).
![Frustrated :wall:](./images/smilies/pictowallsmall.gif)
![Frustrated :wall:](./images/smilies/pictowallsmall.gif)
Tried changing the left/right front scribes to -.75", which resulted in the left/right pieces being shortened to where the miters correctly met the front edges of the cabinet, but then the front piece was just floating out in front of the cabinet, disconnected.
![Question :?:](./images/smilies/icon_question.gif)
![Frustrated :wall:](./images/smilies/pictowallsmall.gif)
![Flaming :fire:](./images/smilies/pictofiresmall.gif)
![Question :?:](./images/smilies/icon_question.gif)
This is a plain faceframe cabinet with no top (at this point).
Any ideas ?