Finished side out instead of in

BenRatt · Post by **BenRatt** » Thu, Jul 30 2009, 10:55PM

Not a gripe, just a suggestion- Would anybody out there vote to make a check box option to have the finished side out instead of facing in? This could be in the construction settings dialog.I do a lot of integral laminate finished ends and have to list that material as "upside down" b/c by default the finished side of one sided material faces the inside of the cabinet. I could get better yield per sheet if I could nest finished ends and door/drawer front together on the same sheet, instead of having to run one face up and one face down. Thanks for all you do ecab programmer dudes

Jeremy Schiffer · Post by **Jeremy Schiffer** » Thu, Jul 30 2009, 10:59PM

I'm with you 100% Ben, I think this would be a great addition, for exactly the same reasons. Count my vote on this one.

Roger Kirkpatrick · Post by **Roger Kirkpatrick** » Fri, Jul 31 2009, 1:03PM

My vote also.
Good idea.
I run across this all the time.

Donald Thomson · Post by **Donald Thomson** » Sun, Aug 02 2009, 11:58AM

eCabinets Developers,

Please, can you include this feature?

Thank you!!!!!!

Thermwood / eCabinet Systems

Finished side out instead of in

Finished side out instead of in

Re: Finished side out instead of in

Re: Finished side out instead of in

Re: Finished side out instead of in